Technical Information
39
G 1xxx/G 2xxx
Function Programming Display
Second interim rinse
Select 2nd interim rinse.
Select a setting and
confirm with OK.
Options: On, Off (standard setting).
Machine height setting
3
Select Machine height.
Select a setting and
confirm with OK.
Options: Normal (G 1xxx),
XXL (G 2xxx).
Country setting
3
Select Country version.
Select a setting and
confirm with OK.
Options: EUR (Europe), AUS
(Australia), USA, JPN (Japan), I/E
(Italy/Spain), SER (S. Europe).
4
Model setting
3
Select Model type. Select
a setting and confirm with
OK.
On models with a salt container in
the door, this option must be set to
0. If the dishwasher does not have
a salt container in the door , 1 must
be selected.
Table 26: Service Programming Mode, G 2630/G 2670
1
In machines with ID no. -876, run the update "Optimized cleaning of tea residues in
Sensor Wash program" (mat. no. 06471560). Modified threshold values will improve
the cleaning outcome.
2
This parameter can also be modified by the customer in the Settings menu under
External Water Softeners. See the appropriate operating/installation instructions.
3
If the electronic needs to be replaced during servicing, then the following steps must be
taken during programming: In the first step, set the country specification, then switch off
the machine. Access the programming mode again and set the machine height.
4
SER includes the following countries: Portugal, France, the Netherlands, Belgium and
Great Britain.
Save and quit:
Switch off the appliance.
2.11 Excella - G 2732
Initial requirements:
1. Close the door.
2. Switch off the appliance.
Accessing:
1. Press and hold the Start button.
2. Switch on the appliance.
3. Release the Start button when the display lights up.
4. Immediately press the Start button 5 times; on the 5th time, hold it
pressed in until the display shows the first 3 programmable functions
(Reset/Language/Time of day).
Acknowledgement indicator:
The LEDs are all off and setting options are shown in the display.
To Next Page
