installation
5. Leve_ the _egs
[] The rear leveling legs can be
adiusted with a T20 Torx screwdriver
by turning the screws at the front of
the slide skis,
To raise the machine turn clockwise,
To lower the machine turn counter
clockwise,
Several turns may be needed to set the
correct heighL Do not use a power
screwdriver.
[] Adiust the front leveling legs by
pushing on the feet with a slotted
screwdriver,
[] Tipping the machine slightly
backwards, if posssible will make
adjusting the front legs easier, Make
sure the machine is level when
adjustments are complete,
_i The dishwasher should be raised
until it just touches the underside of
16
To Next Page
Loading...
