Miele G 6570 - Energy Management; At the End of a Programme

Operation
48
Energy management
To save energy, the dishwasher will
switch off automatically 10 minutes
after the last time a button has been
pressed or 10 minutes after the end of
the programme (see "Settings menu,
Optimise standby").
 Press the  button to switch the
dishwasher back on.
The dishwasher will not switch off
whilst a programme or the FlexiTimer
is running or if there is a fault.
At the end of a programme
At the end of a programme, the In-
operation indicator light will be visible
flashing slowly with the door shut. The
buzzer might also be sounding.
The programme has finished when 
Finished appears in the display and the
door has opened slightly (if applicable).
If the Consumption programmable
function is switched on, you can now
call up the actual energy and water
consumption of the programme which
has just finished (see "Caring for the
environment, EcoFeedback
consumption indicator").
The drying fan may continue to run for
a few minutes at the end of the
programme.
 Open the door completely to re-
engage the door closing mechanism.
You can now empty the dishwasher.
The In-operation indicator light will go
out 10 minutes after the end of the
programme if the door is closed.
 If you have deactivated the
automatic door opening function
(see "Settings menu, AutoOpen"),
but would still like to open the door
at the end of the programme, then
make sure that you open the door
fully.
Otherwise steam from the
dishwasher could damage the edge
of the worktop because the fan is no
longer running.