Miele G 6570 - Programme-Specific Settings

Settings menu
91
Sensor wash
You can adjust the Sensor wash
programme so that it will remove
stubborn soling in a lightly soiled load.
 Select the setting you want and
confirm with OK.
AutoOpen
At the end of programmes with a drying
phase (except Extra quiet) the door will
open automatically a little in order to
help the drying process (see
"Programme chart").
This function can be deactivated if
wished.
 Select the setting you want and
confirm with OK.
 If you have deactivated the
automatic door opening function but
would still like to open the door at
the end of the programme, then
make sure that you open the door
fully. Otherwise steam from the
dishwasher could damage the edge
of the worktop because the fan is no
longer running.
BrilliantLight
This dishwasher has interior lighting.
When the door is open the lighting will
switch off automatically after 15
minutes.
You can also switch off the interior
lighting permanently.
 Select the setting you want and
confirm with OK.
Optimise standby
The dishwasher is supplied with the
Optimise standby function set as
standard.
To save energy the dishwasher will
switch off automatically a few minutes
after the last time a button has been
pressed or after the end of a
programme.
The dishwasher will not switch off in
the event of a fault.
Optimise standby can be switched off if
you prefer. If you do this the duration
before the dishwasher switches off
increases to 6 hours. Doing this will
increase energy consumption.
 Select the setting you want and
confirm with OK.