Operation
48
Energy management
To save energy, the dishwasher will
switch off automatically 10 minutes af‐
ter the last time a button has been
pressed or 10 minutes after the end of
the programme (see "Settings menu,
Optimise standby").
Press the button to switch the
dishwasher back on.
The dishwasher will not switch off
whilst a programme or the FlexiTimer
is running or if there is a fault.
At the end of a programme
At the end of a programme, the In-op‐
eration indicator light will be visible
flashing slowly with the door shut. The
buzzer might also be sounding.
The programme has finished when
Finished appears in the display and the
door has opened slightly (if applicable).
If the Consumption programmable func‐
tion is switched on, you can now call up
the actual energy and water consump‐
tion of the programme which has just
finished (see "Caring for the environ‐
ment, EcoFeedback consumption indi‐
cator").
The drying fan may continue to run for
a few minutes at the end of the pro‐
gramme.
You can now empty the dishwasher.
The In-operation indicator light will go
out 10 minutes after the end of the pro‐
gramme if the door is closed.
If you have deactivated the auto‐
matic door opening function (see
"Settings menu, AutoOpen"), but
would like to open the door as soon
as the programme has finished make
sure that you open the door fully.
Otherwise steam from the dishwash‐
er could damage the edge of the
worktop because the fan is no longer
running.
To Next Page
Loading...
