Increasing the water intake
time
Position the right hand switch verti-
cally and then pull it off.
Using a 4-5 mm wide screwdriver
turn the adjuster mechanism to the
right hand side of the spindle
carefully in an anti-clockwise direc-
tion until it checks into position.
= Anti-clockwise turn (increases
water intake – 2 min.)
= Clockwise turn (factory
setting – 1 min.)
Note:
If the water intake time has been in-
creased, then the water hardness selec-
tor must be reset at one grade higher
than that stated in chapter “Water sof-
tener” (except with setting 6).
Checking the water level
42
To Next Page
Loading...
