Miele G 686 - Water Flow and Drainage Faults

Problem Possible cause Remedy
The indicator light
“Inlet/Outlet” is flashing
shortly after the pro-
gramme has started
The stopcock is closed. Open the stopcock fully.
If the programme still
does not start:
– Turn the programme
selector to the “Stop”
position.
– Switch the dishwasher
off using the “On/Off”
button.
– Start the programme
again.
The water pressure at the
intake is lower than 0.3
bar.
Seek professional advice.
The water inlet filter is
blocked.
Before rectifying the
problem you must:
– Turn the programme
selector to the “Stop”
position.
– Switch the dishwasher
off using the “On/Off”
button.
then:
– Check the water inlet
filter and clean if
necessary.
The indicator light
“Inlet/Outlet” comes on
during the “Energy
save” programme
The incoming water has
not reached the minimum
required temperature of
45 °C , the hot water
system may be
overloaded (see
“Programme selection”).
– Start the programme
again.
– If the indicator light
comes on again select
a different programme.
Problem solving guide
46