Adding neutralising agent and (liquid) detergent
Adding neutralising agent
To reduce the pH to neutral after alkaline
cleaning, special neutralising acids can
be used in programme stage 4.
Important "Special functions" must first
be used to set the programme to dis-
pense neutralising agent in stage 4, in-
stead of rinsing agent.
When the w indicator light on the con-
trol panel lights up:
Fill the container DOS 10 (red mark-
ings) with neutralising agent, or
change containers, and then:
Place the siphon tube firmly in the
opening of the free-standing con-
tainer (pay attention to colour cod-
ing).
Re-fill the container in good time, it
should never be allowed to empty com-
pletely.
Adding detergents
Detergent can be added in either liquid
or
powder form (for powder detergent,
see relevant section, p. 18)
When the indicator light "DOS" on the
control panel lights up:
Fill the container DOS 60 (blue mark-
ings) with liquid detergent, or
change containers, and then:
Place the siphon tube firmly in the
opening of the free-standing con-
tainer (pay attention to colour cod-
ing).
Re-fill the container in good time, it
should never be allowed to empty com-
pletely.
Note: If adding an extra dose of deter-
gent in the pre-wash of programmes E
and F (see "Programme chart"), only
powder detergent can be used.
Adding neutralising agent and (liquid) detergent
18
To Next Page
Loading...
