Programming the water hardness
level
^
Switch the dishwasher off with the
On/Off button I-0.
^
Press the +c and h/f buttons in
and whilst holding them in switch
the dishwasher on with the On/Off
button I-0.
Then release these buttons.
The "Main wash/Rinses" l indicator
light will come on and the "Salt" k
indicator light will flash.
If this does not happen, start the
procedure from the beginning again.
If the following flashes in the timer
display: a 19
The water hardness level has been set
to 2.5 mmol/l (19 °d).
^
Use the programme selector buttons
%$ to select the value that
corresponds to your water hardness
level (see chart on the right).
Use the % button to scroll down and
select a lower value.
Use the $ button to scroll up and
increase the value.
The value selected will appear in the
display.
A two digit value flashes in the display
with one figure alternating with the
other.
^ Press the Start/Stop button h/f
twice.
The indicator light beside the h/f
button will flash.
The programmed water hardness level
is now stored in memory.
^ Switch the dishwasher off with the
On/Off button I-0.
Before using for the first time
14
To Next Page
