Problem Possible cause Remedy
The "Water inlet"
indicator light is flashing
and the programme does
not continue.
Before rectifying the
problem you must:
–
Press the "Start/Stop"
button for at least one
second.
–
Start the programme
again.
The stopcock is closed. Open the stopcock fully.
The water inlet filter is
blocked.
Before rectifying the
problem you must:
–
Press the "Start/Stop"
button for at least one
second.
– Switch the dishwasher
off using the "On/Off"
button.
Then:
– Clean the water inlet
filter, see "Cleaning the
water inlet filter".
The water pressure at the
intake is lower than
0.3 bar.
Seek professional advice.
Problem solving guide
47
To Next Page
Loading...
