Technical Information
108
G 600/G 800
Programming Flow Chart
Enter Service Mode 2
To access:
Error messages
Operating hours
Flow meter pulses
Increased water temperature selection
Water softener (with/without)
Extended water intake
Interim rinses
Extended fan time (+45 min)
EGS
Table 6-40: G 891 Programming Flow Chart
6.8.8.1 Programming Mode
1. To access the programming mode, close the door and turn the dishwasher on.
All program lights should light. If not, press the Start/Stop button to cancel the
program. Turn the dishwasher off.
2. Press and hold the “+”and Start/Stop buttons while turning the dishwasher on.
Successful accessing of the programming mode is indicated by a blinking Salt
light and the display showing P00, P01, etc., depending on the electronic version.
3. Press the appropriate program button indicated in Table 6-41 to modify the
corresponding function.
4. Use the Top solo button to toggle the functions on or off.
5. After selecting options, press the Start/Stop button twice and turn the
dishwasher off.
Program button Function Options Display
Sani Wash
Water hardness
setting
0 gpg
1 - 36 gpg
2 3
0
1 - 36 gpg
Rinse & Hold
Extended drying time
(+14 min)
4 min
14 min
90
91
Table 6-41: G 891 Programming Functions
1
If “0” is displayed, the dishwasher is programmed for “without water softener”. To change to “with
water softener”, follow the steps in Service Mode 2 (Section 6.8.8.3).
2
Factory setting
3
Use 36 gpg for setting water hardness of 36 to 70 gpg.
6.8.8.1.1 Setting the Water Hardness
1. Measure the water hardness in grains per gallon (gpg).
2. Access Programming Mode.
3. Press the Sani Wash button. Use the Top solo button to toggle through to the desired
water hardness amount.
4. To save: Press the Start/Stop button twice and turn the dishwasher off.
6.8.8.1.2 Checking the Water Hardness Level
1. Access Programming Mode.
2. Press the Sani Wash button.
3. The number in the display will indicate the programmed water hardness setting.
4. Turn the dishwasher off.