Miele G6722 - FlexiTimer with EcoStart

Programme options
58
FlexiTimer with EcoStart
The FlexiTimer  gives you three ways
of starting the programme by means of
delaying the start. You can set the start
time or the finish time of a programme.
You also have the option of taking
advantage of time variable economy
rates of electricity using the EcoStart
function.
When using the Delay start function,
make sure that the detergent
compartment is dry before adding
detergent. Wipe dry with a cloth if
necessary. If the compartment is
wet, powder detergent can become
lumpy and stick to the dispenser,
with the result that it is not fully
dispensed.
Do not use liquid detergent when
selecting Delay start, as it can run
into the dishwasher before it is
required.
 To prevent children coming into
contact with dishwasher detergent:
Do not fill the detergent dispenser
until just before starting the
programme, i.e. before you activate
the FlexiTimer with OK. Also activate
the door safety lock.
 Switch the dishwasher on with the
button.
The Start indicator light will flash.
 Select the required programme.
 Press the button.
You can use the arrow buttons to
select the Start at, Finish at, EcoStart or
Back  function.
 Confirm selection of the function you
want with OK.
The current time of day will appear and
the hour number block will be
highlighted.
You can now enter the time you want
using the  arrow buttons and
confirm with OK.
If, while you are setting the time, you do
not press any buttons for several
seconds, the display will revert to the
previous menu. You will then have to
enter your settings again.
If the time of day (clock) display has
been switched off (see “Settings menu
- Time of day”), the display will go out
after a few minutes and only the Start
indicator light will flash slowly.
Press any button to switch the display
back on again for a few minutes.