Problem solving guide
72
With the help of the following guide, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting Miele. This will save time and money.
Please note that a call-out charge will be applied to unnecessary service visits
where the problem could have been rectified as described in these operating
instructions.
Unauthorised or incorrect repairs could cause personal injury or damage to
the appliance.
Repair work to electrical appliances must only be carried out by a suitably
qualified and competent person in strict accordance with current local and
national safety regulations. The manufacturer cannot be held liable for
unauthorised work.
Technical problems
Problem Possible cause and remedy
The display remains
dark and the Start
indicator light is not
flashing after the
dishwasher has been
switched on with the
button.
The appliance is not plugged in.
Insert the plug and switch on at the socket.
The mains fuse has tripped.
Reset or replace the fuse (see data plate for
minimum fuse rating).
The dishwasher stops
during a programme.
The mains fuse has tripped.
Reset or replace the fuse (see data plate for
minimum fuse rating).
If the mains fuse trips again, call Miele.
The time display is
flashing with the door
shut. The programme
has not started.
The door has not closed properly, because it had not
been fully opened after the door had been opened
automatically.
Open the door fully so that the door catch rail
retracts again.
Then close the door.
To Next Page
Loading...
