Miele G6722 - Water Inlet Fault

Problem solving guide
74
Water inlet fault
Problem Possible cause and remedy
One of the following
messages appears in
the display:
Open stopcock The tap is turned off.
 Turn on the tap fully.
Water intake Before rectifying the problem, you must:
 Switch the dishwasher off with the  button.
Water intake is restricted.
 Turn on the tap fully and start the programme
again.
 Clean the water inlet filter (see “Maintenance”).
 The water pressure at the intake is lower than 50
kPa (0.5 bar).
Seek professional advice.
The following message
appears in the display
during the SolarSave
programme:
 Intake temp. low
The intake water has not reached the required
temperature of 45°C (see “Water connection -
Connection to the water supply”).
 Start the programme again.
 If the fault message appears again, select a
different programme.