Settings menu
94
Rinse aid
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage is set in stages
from 0 to 6.
It is set to 3 at the factory.
If the “Adjust Automatic” programme
function (depending on model) has
been activated, the amount of rinse aid
dispensed in the Automatic programme
can be higher than that set.
If spots appear on crockery and
glassware:
– Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
– Decrease the rinse aid dosage.
Select the setting you want and
confirm your choice with OK.
Consumption (EcoFeedback)
You can programme the dishwasher so
that the energy and water consumption
of the currently selected programme
appears in the display. The estimated
consumption can be displayed before
the programme starts and the actual
consumption can be displayed after the
programme has finished.
In this menu you can also call up the
total energy and water used in all
previous dishwasher programmes (see
“Caring for the environment -
EcoFeedback consumption indicator”).
Consumption indicator
Select the Display option and confirm
with OK.
Select the setting you want and
confirm with OK.
Total consumption
Select the Total consumption option
and confirm with OK.
You can call up the values for Energy
and Water with the arrow
buttons.
You can also reset the values for the
total consumption to 0.
Select the Reset option and confirm
with OK.
Select the Yes option and confirm
with OK.
Confirm the message with OK.
The values are now reset to 0.
To Next Page
Loading...
