Installation
^
Remove the cable clip from the back
of the appliance.
^
Check that all parts at the back of the
appliance are unhindered. Carefully
remove any hindrance.
^
Carefully push the appliance into
position.
^
Push the appliance so that the wall
spacers (if fitted), or the rear of the
appliance, are directly against the
wall.
Aligning the appliance
^
To align the appliance, adjust the
front feet using the spanner supplied.
On stainless steel appliances
^
If necessary, also align the two rear
adjusting devices a using socket
wrench b.
Turn the adjusting device clockwise
to raise the appliance up at the back.
Supporting the appliance door
^
The foot c should definitely be
unscrewed until it rests on the floor.
Then turn it a further 90°.
Installation
50
To Next Page
Loading...
