Before installation
^
Before installation remove the cover
strip, sealing strip and other
accessories from inside the
appliance and from the external rear
wall of the appliance.
^ On no account should you remove
– the spacers from the back of the
appliance.
These ensure the gap required
between the back of the appliance
and the wall is maintained.
– the bags (depending on model)
located between the rear wall of the
appliance and the metal grille (heat
condenser).
These are important for the correct
functioning of the appliance. Their
contents are non-toxic and not
dangerous.
^
Remove any cable clips from the
back of the appliance.
^
Remove the red transit bars a and
seal the resulting holes with the caps
b supplied.
^ Check that all parts at the back of the
appliance are unhindered. Carefully
remove any hindrance.
Does your old appliance have
a different hinging
mechanism?
If your old appliance had a different
type of hinging, the furniture door can
still be used. Remove the old hinges
from the housing unit. They are no
longer required because the furniture
door is now fitted to the appliance door.
All the necessary parts are supplied or
can be ordered from Miele.
Installation advice
35
To Next Page
