Safety feature
This appliance is equipped with an
Ignition Safety Control. This control cuts
the gas supply if the flame goes out
and reignition is unsuccessful.
^
To reignite the burner, turn the control
knob to "ß", then follow the procedure
outlined in "Turning on and off /
Regulating".
This safety feature is not operated by
electricity, it will be active even if the
appliance is in use during a power
failure.
Using the cooktop during a
power failure
If there is an interruption to the
electrical supply, the gas can be
ignited using a match.
^
Press down and turn the desired
control knob counterclockwise to the
largest flame symbol.
^
While holding down the knob, light
the gas at the burner with a match.
^
When the flame appears, keep the
control knob pressed in for 8 - 10
seconds to allow for the Ignition
Safety Control to reach operating
temperature.
Using the cooktop
14
To Next Page
Loading...
