The temperature being set will flash in
the display.
The following information shows in the
display when the buttons are tapped:
–
When first touched:
The last temperature selected
flashes.
–
Each subsequent touch of the
button:
The temperature value adjusts in 1°
steps.
–
Keeping your finger on the button:
The temperature changes
continuously.
Approximately 5 seconds after the last
time a sensor button has been touched,
the current temperature inside the
appliance is automatically shown.
When the temperature is altered, there
is a short delay until the temperature
selected is set.
The temperature display on the
control panel always shows the
actual temperature.
Possible setting values for the
temperature
In both zones, it is possible to set
temperatures between 41°F and 68°F
(5°C and 20°C).
Temperature display
In normal operation, the temperature
display shows the actual temperature in
the zone.
If the temperature in one of the zones is
not within the range that the appliance
is able to display, dashes will light up in
the temperature display.
Depending on the ambient temperature
and the temperature setting, it can take
the appliance a few hours to reach the
temperature required and for this
temperature to then be shown as a
constant temperature in the display.
Temperature and air quality
22
To Next Page