If this is the case, the following message will appear:
A
Accept scanned loads?
Yes
No
^
Confirm by pressing
Yes.
The list of all scanned loads will appear in the display:
Select scanned loads A
1_14.02.2007_08:23
2_14.02.2007_09:11
^ Select the scanned load you require and confirm with OK.
The h button will flash and the programme can be started.
When the message
Process parameters achieved comes
up at the end of the programme, the scanned loads which
have been reprocessed will disappear from the display.
The scanned load which was last to be processed will not
disappear from the display:
–
when a programme is cancelled or if a fault has occurred
during a programme (
Process parameters not achieved),
–
in programmes where the parameter
Report process from
in the programme header is not defined.
When the programme is restarted, the scanned load will be
processed again. It can either be deleted manually or placed
further down the list.
If none of the saved scanned loads are to be accepted:
^
Select and confirm
No .
^
Scan the load will appear in the display.
^
Scan the load manually, as described in "Scanning the
load".
Barcode scanner (optional)
57
To Next Page
Loading...
