How to change the fine filter
If
Change fine filter appears in the
display, the HEPA filter needs to be
replaced..
To ensure optimal performance, use
only original Miele HEPA filters
(classification 13).
It is best to have the fine (HEPA) filter
replaced directly by Miele Service
during routine maintenance.
If that is not possible, the fine filter can
be changed as follows:
^ Pull open the control cabinet drawer.
^ Unscrew the upper screws on the
coarse filter housing and lift upward.
^
Remove the coarse filter housing.
^
Remove the fine filter and insert a
new one.
^ Reinsert the coarse filter housing and
flip the screws downward.
^ Tighten the screws.
^ Close the control cabinet drawer.
After changing the HEPA filter, you
must reset the operating hours counter.
To do this:
^
Select
CHANGE FINE TA and start
the program by pressing the h
button.
When the service program has finished,
the display will show a message.
^
Confirm this message with OK.
The system displays the program
overview.
Maintenance of the washer-disinfector
65
To Next Page
Loading...
Need help?
General
