Cleaning and maintenance
27
Now lay the cleaning cloth back on the infeed table, but this time
move it slightly to the right. The cleaning strip must again face the
heater plate.
Feed the cleaning cloth through the ironer again.
Repeat the process until you reach the right side of the infeed table
and the entire width of the heater plate has been cleaned.
It is essential to wax the heater plate after cleaning.
Waxing the heater plate
To start waxing mode, press and hold the button for at least
3seconds and then press the temperature selection button.
The button will start to flash as soon as the ironer has reached
the temperature range.
To deactivate waxing mode, press and hold the button again for
at least 3seconds.
If waxing has been successfully carried out in waxing mode for a
period lasting at least 40seconds, the maintenance interval for
prompting the cleaning and waxing of the heater plate (= red sym-
bol) will be reset.
Waxing with the
waxing cloth
Sprinkle some wax into the pocket of the waxing cloth.
Use the wax sparingly to avoid the ironing cloth becoming too
smooth.
Close the pocket.
Press the button to start the waxing process.
Lay the waxing cloth with the rubber-coated side facing down-
wards (i.e. towards the roller) and feed it into the heated flatwork
ironer (heater plate temperature: approx. 180°C).
Do not feed in the wax cloth with the rubber-coated side facing up-
wards (i.e. towards the heater plate).
To Next Page
Loading...
Need help?
General
