Installation
*INSTALLATION*
44
Connecting the ProLine element
Connect the ProLine element/
elements to the electricity supply and
to the gas supply (see “Installation –
Electrical connection” and “Gas
connection”).
Checking operation
After installation, ignite all burners to
check that they are operating
correctly:
- The flame must not go out on the
lowest setting, or when the control is
turned quickly from the highest to the
lowest setting.
- On the highest setting, the flame
must have a distinctive and visible
core.
Removing a ProLine element
If the ProLine element is accessible
from below, push it upwards to
remove it. Push the back of the
appliance out first.
If the ProLine element is not
accessible from below, take hold of
the appliance with both hands at the
back, pull it forwards, then lift it up
and out.
To Next Page
Loading...
