Installation
45
Granite and marble worktops
You will need heavy duty double-sided
tape (not supplied) to secure the
spring clamps and spacer bars.
Stick the tape to the top edge of
the cut-out in the positions shown in
the diagram.
Position the spring clamps and
spacer bars on or at the top edge
of the cut-out and press them firmly
into place.
Apply silicone to the side and lower
edges of the spring clamps and
the spacer bars.
Then fill the gap between the
spacer bar and the worktop with
silicone.
To Next Page
Loading...
Need help?
General
