Fault messages
Indicator / display Possible cause Remedy
N 0
Over-pressure in vent ducting.
Leaks in the airways.
Check the vent ducting.
Call the Service Department.
N W
Fluff filter blocked Clean the fluff filter.
Gas burner malfunction Press the START/STOP button.
Other messages
Peak load cut-out
The dryer will continue to run without
heating (cold) for the remainder of the
programme.
If the peak load cut-out is overridden, the
programme will continue as normal.
In the event of any faults please contact your Dealer or the nearest Service Department.
When contacting the Service Department, please quote the Model,
Serial number (Fabr.Nr) and Material number (M.Nr) of your machine.
These are shown on the data plate.
The data plate is located at the top of the door aperture with
the door open or at the top of the rear of the machine.
Problem solving guide
18
To Next Page
Loading...
