Miele PT 8331 + COP - Description of Dryers PT 8253, 8333, 8403, 8503, 8803

Control panel PT 8253, 8333, 8403, 8503, 8803 Profitronic B Plus Residual moisture programmes
12
3456 7 8
1 Segment display - Residual moisture 2 Programme sequence display
3 Low temperature (additional option) button 4 Venting system fault indicator
5 Fluff filter fault indicator 6 START/STOP button
7 Programme selection rotary control 8 On/Off switch
Mains On/Off switch s
Switches the machine on or off.
Low temperature (additional option) button K
Lowers the drying temperature (by approx. 20°C).
Use for delicate fabrics (e.g. synthetics). The LED will
light up.
Programme selection rotary control
For selecting the drying programme.
A: Minimum iron
Drying
Moisture 10%
Moisture 20%
B: Cottons
Drying plus
Drying
Moisture 20%
Delicates Moisture 25%
Moisture 40%
Woollens
Timed drying warm Timed drying cold
START/STOP button
Press the Start/Stop button to start or stop the drying
programme.
Segment display
Before the start of a programme this shows the
residual moisture which has been allocated to the
programme as a %.
After the start of a programme it shows the residual
moisture which is currently in the laundry until the
programme is finished.
It also shows fault messages, see "Problem solving
guide".
It can also show h for "Peak load cut-out" (optional).
Programme sequence display
The programme sequence is displayed in three
stages. The stage the programme is at will be
highlighted in yellow.
! Drying
L Cooling down
O Programme finished / Anti-crease
Check venting system 0 fault indicator
This will light up if there is a problem with the venting
system.
Clean the fluff filter W fault indicator
This light up when the fluff filter needs to be cleaned.
Description of dryers PT 8253, 8333, 8403, 8503, 8803
9