29
Unlock the motor protection filter by
turning it anti-clockwise and lift it up-
wards to remove it.
Risk of damage caused by incor-
rect cleaning.
The pre-filter can become damaged
and be less effective as a result.
Do not use pointed or sharp-edged
objects to clean the filter.
Carefully knock the dust out of the
pre-filter over a bin.
Tip: Use a tool like a fine cleaning brush
to clean the inside of the pre-filter thor-
oughly.
You do not need to clean the motor pro-
tection filter. It can be removed so that
the inside of the pre-filter is easier to
reach.
After cleaning the pre-filter, place the
motor protection filter back into the
pre-filter securely, making sure it is
properly positioned.
Lock the motor protection filter by
turning it clockwise as far as it will go.
Replace the pre-filter in the dust con-
tainer.
To do this, line up the guide lines on
the two sections and turn the dust
container lid back to its original posi-
tion.
Close the cover at the bottom of the
dust container, making sure it clicks
into place.
Replace the fine dust filter.
Replace the dust container on the
PowerUnit connector.
To Next Page
Loading...
