30
Cleaning the dust container
Clean the dust container as required.
Remove the dust container.
Empty the dust container over a bin
and lift the pre-filter upwards to re-
move it.
Clean the dust container using water
and mild washing-up liquid.
Dry the dust container thoroughly.
Replace the pre-filter in the dust con-
tainer.
Replace the dust container on the
PowerUnit connector.
Cleaning the Electrobrush/handheld
brush
(The availability of the handheld brush
depends on the model)
Separate the Electrobrush/handheld
brush from the vacuum cleaner con-
nector.
Removing threads and hairs
Place the Electrobrush/handheld
brush upside down on a level, clean
surface.
Cut any threads or hairs that have
wound themselves around the roller
brush with a pair of scissors. To guide
the scissors, move along the guide
track on the roller brush.
Then run the vacuum cleaner to va-
cuum up the cut threads and hairs.
Removing the roller brush
(Not possible with the handheld brush)
You can take the roller brush out of the
Electrobrush in order to remove stub-
born soiling and clean the inside of the
Electrobrush.
To Next Page
Loading...
