Pull out the heat exchanger.
Clean the heat exchanger at both
ends (front and back).
and along the two long sides.
Wipe the rubber seals at both ends
gently but thoroughly.
Shake any excess water out of the
heat exchanger until no more water
droplets are visible. Then stand the
heat exchanger lengthwise on a
towel until it is quite dry.
Replace the heat exchanger in the
reverse order.
Attempt to pull forward the heat ex-
changer and the cover to check that
both are firmly positioned, as other-
wise water may leak from the ma-
chine.
Replace the service panel, fitting it in
first at the bottom and then pressing
it in along the top edge until it en-
gages in position.
Cleaning and care
19
To Next Page
Loading...
