Pull the condenser unit out.
Clean the condenser unit at both
ends (front and back).
Wipe the rubber seals at both ends
gently but thoroughly.
Clean the two long sides of the unit.
Stand the condenser unit lengthwise
on a towel until it is quite dry.
Replace the condenser unit (see il-
lustration above left).
Return both levers on the condenser
unit to the horizontal position.
Pull forwards on the unit to check
that it is firmly in place.
Replace the cover and check that it
is also firmly in place, otherwise
water may leak from the machine.
Close the door.
Cleaning and care
27
To Next Page
Loading...
Need help?
General
