Miele TOUCHTRONIC T 8002 - Installation Beneath a Counter

Installation beneath a counter
,
When removing the machine lid
to reduce the height of the machine,
a built under spacer kit*is
necessary.
It must be installed by a Miele
Service Technician.
The cover plate of the built under kit
replaces the appliance lid and
ensures electrical safety.
An installation manual is supplied with
the built-under spacer kit.
The electrical connection should be
near the dryer and accessible at all
times.
Provide necessary space for the
ducting when planning the
undercounter installation.
Extended machine feet* are
recommended at a built-in height of
more than 33
1
/
16
" (840 mm).
^
Set the extended machine feet at a
height of 1
9
/
16
" (40 mm).
Remove the original machine feet
and replace them with the extended
ones.
One or two filler frames* are
recommended at a niche height of
34
1
/
4
"to34
13
/
16
" or 36" to 36
5
/
8
"
(870-885 / 915-930 mm).
* (optional accessory)
An existing continuous toe kick must
be interrupted at the dryer location!
Reinstallation of the machine lid
^
When reinstalling the appliance lid,
check the firm fit of the cover at the
rear bracket for safe transport of the
dryer.
Installation
28