EasyManuals Logo

Miele TWB 140 WP User Manual

Miele TWB 140 WP
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
Installation
*INSTALLATION*
59
Downtime after installation
Damage to the tumble dryer by
switching it on too soon.
This can damage the heat pump.
After setting up the tumble dryer,
wait for at least one hour before
switching it on.
Ventilation
The cool air intake at the front of the
tumble dryer must not be blocked or
covered. This would hinder a
sufficient intake of cool air for the
heat exchanger.
Do not block the gap between the
bottom of the tumble dryer and the
floor with plinth facings, deep pile
carpet etc. This would hinder a
sufficient flow of air to the tumble
dryer.
Adequate ventilation has to be
provided to avoid the backflow of
gases into the room from appliances
burning other fuels, including open
fires.
Air which is taken in to cool the heat
exchanger is then blown back out of the
dryer and warms up the air in the room.
Ensure sufficient ventilation of the
room, e.g. by opening a window. The
drying time will otherwise take longer
(higher energy requirement).
The heat pump that is essential to
the operation of this tumble dryer
generates a lot of heat inside its
casing. It must be possible to
dissipate this heat well.
Otherwise loads could take longer to
dry or the tumble dryer might sustain
damage in the long term.
Permanent room ventilation during
every drying programme and the
ventilation gap between the bottom
of the tumble dryer and the floor are
mandatory requirements at all times.
Before moving the tumble dryer
again (e.g. when moving house)
After each use a small quantity of
condensed water will collect in the area
of the pump. This water can run out if
the tumble dryer is tipped up when it is
being moved. Recommendation: Run
the Warm air programme for
approximately 1minute without a load
before moving the tumble dryer. Any
remaining condensed water will then be
fed into the condensed water container,
which can then be emptied, or can
drain out through the drain hose.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Miele TWB 140 WP and is the answer not in the manual?

Miele TWB 140 WP Specifications

General IconGeneral
Drum typeHoneycomb
Color nameLotus white
Door hingeLeft
Door styleOpaque door
Cord length2 m
Control typeRotary, Touch
Loading typeFront-load
Drying systemHeat pump
Product colorWhite
Reversible doors-
Appliance placementFreestanding
Inverter technologyYes
Cycle time155 min
Noise level66 dB
Drying classA
Drum capacity7 kg
Refrigerating mediumR290
Refrigerating medium weight110 g
Current13 A
Heat sourceElectric
Connected load1100 W
AC input voltage220 - 240 V
AC input frequency50 Hz
Energy consumption1.7 kWh
Energy efficiency scaleA+++ to D
Power consumption (off)0.3 W
Annual energy consumption208 kWh
Delay start (max)24 h
Weight and Dimensions IconWeight and Dimensions
Depth643 mm
Width596 mm
Height850 mm
Weight58000 g
Depth with door open1077 mm

Related product manuals