Programmable functions
77
Control panel standby
status
To save energy, the time display and
the sensors will go out once the
programme has been running for
10minutes. In this case, the Start/Add
laundry sensor flashes slowly.
However, there is no switch-off in the
event of a fault.
Options
= Off
The time display and the
sensors do not go out.
= On (factory setting)
The time display and the
sensors will go out once the
programme has been running
for 10minutes.
“Switch on” display again
– Touch the Start/Add laundrysensor.
This will not affect a running
programme.
Memory
You can set the following: The
electronics will memorise the drying
level and any options selected for the
current drying programme. It will also
memorise the duration of the Warm air
programme. When the programme is
selected again, these memorised
settings will appear in the display.
Options
= Off (factory setting)
= On
Exception:
The Cottons programme will
remain unchanged.
Anti-crease
After the programme has finished, the
drum will continue to rotate at intervals
for a max. of 2 hours. This helps
prevent creasing if the laundry is not
removed immediately after the end of
the programme. The duration can be
shortened.
Options
= no Anti-crease
= 1 hour
= 2 hours (factory setting)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
