Frequently Asked Questions
Problem Possible cause and solution
Lines flash and light up
after turning on: .
Program selection is
not possible.
Access via a PIN code has been activated.
See “Programmable functions”, “PIN code”.
and another
number combi-
nation flash after
a program has
been cancelled, a
signal sounds.
There is no obvious cause.
Switch the dryer off and then on again.
Start a program.
If the program is interrupted again and an error
message appears, there is a fault. Contact Miele
Service.
: lights up and the
program has been can-
celled, a signal sounds.
The laundry is unevenly distributed or has rolled up.
Untangle the laundry and remove a few items if
necessary.
Switch the dryer off and then on again.
Start a program.
lit and program start
is not possible.
An update is available for the tumble dryer. See
“Programmable functions – RemoteUpdate” for
more information.
51
To Next Page
Loading...
