Frequently Asked Questions
57
Reactivating the plinth filter
You can reactivate one or more dirty
plinth filters in the washing machine.
You will then be able to use the plinth
filter again.
Prior to reactivation, check that the
plinth filter is in good order. Check the
plinth filter following the instructions
provided in “Frequently Asked
Questions – Replacing the plinth filter”.
Replace the plinth filter if it has worn
out.
Wash the plinth filter(s) separately,
not with any laundry items. Do not
add any detergent.
Select a short wash program with a
maximum temperature of 104°F
(40°C) and a maximum spin speed of
600rpm.
You can re-insert the plinth filter once
the wash and spin cycle is complete.
Checking the heat exchanger
unit
Risk of injury from sharp cooling
fins.
You could cut yourself.
Do not touch the cooling fins with
your hands.
Look to see if lint has accumulated.
Remove any lint you can see.
Damage due to incorrect
cleaning of the heat exchanger.
The tumble dryer will not dry if the
cooling fins are damaged or bent.
Clean using a vacuum cleaner with a
dusting brush attached. Only pass
the vacuum cleaner dusting brush
over the heat-exchanger fins lightly,
without applying any pressure.
Vacuum up any lint and residues.
To Next Page
Loading...
