Miele TXD 160 WP - Page 83

Programmable functions
83
Control field switch-off
status
To save energy, the time display and
sensor buttons will go out once the
program has been running for
10minutes. In this case, the Start/Add
laundry sensor button flashes slowly.
However, there is no switch-off in the
event of a fault.
Options
 = Off
The time display and sensor
buttons do not go out.
 = On (factory default)
The time display and sensor
buttons will go out once the
program has been running for
10minutes.
“Switching on” the display again
- Touch the Start/Add laundry sensor
button. This will not affect a running
program.
Memory
You can set the following: the
electronic will save the drying level
and any options selected for the
current drying program. It will also
save the duration of the Time Dry/
DryFresh program. When the program
is selected again, these saved settings
will appear on the display.
Options
 = Off (factory default)
 = On
 Anti-crease
After the drying cycle has finished, the
drum will continue to rotate in a
special Anti-crease rhythm for a max.
of 2 hours. This helps to prevent
creasing if the laundry is not removed
immediately after the end of a
program. The duration can be
shortened.
Options
 = No Anti-crease (factory
setting)
 = 1 hour
 = 2 hours