The wash programme stops and a fault indicator light comes
on.
Fault indicator Possible cause Remedy A
The Check drain light
flashes.
The water outlet is
blocked.
Clean the fluff (drain) fil
-
ter and drain pump.
The drain hose has been
fixed too high.
The maximum drain
height is 1 m.
The Check inlet light
flashes.
The water inlet is blocked. Open the stopcock.
The filter in the water inlet
hose is dirty.
Clean the filter.
The Soak/Pre-wash or
Rinses indicator light
flashes in the
programme sequence.
There is a fault. Start the programme
again.
If the fault indicators oc-
cur again, contact the
Service Department.
A To switch off the fault indicator: switch the washing machine off with the I-ON/0-
OFF button and turn the programme selector to
Finish
.
Problem solving guide
40
To Next Page
Loading...
