Follow steps A to G to programme
and store a setting in memory.
The programmable functions are acti
-
vated to call up further features not
shown on the control panel by using the
additional option buttons in combina
-
tion with the programme selector.
Before you begin, first ensure that:
–
The washing machine is switched off.
–
The drum door is closed.
–
The programme selector is at
Finish
.
A Press the START button and keep it
pressed in whilst carrying out steps
B to C.
B Switch the machine on with the I-ON/
0-OFF button.
C Wait until the START indicator light
comes on . . .
D . . . and then release the START but-
ton.
E Turn the programme selector to the
COTTONS 75°C position:
The
Soak/Pre-wash
sequence indica
-
tor light will briefly flash twice in 2
second intervals, to show that factory
Setting 2 is stored in memory.
F Each subsequent press on the
START button selects a different set
-
ting.
The
Soak/Pre-wash
sequence indicator
light will flash:
–
x 1 = Setting 1
higher rinse water level selected
– x 2 = Setting 2
higher water level in the main wash
and rinses (factory setting)
– x 3 = Setting 3
extra rinse in the
COTTONS programme
– x 4 = Setting 4
higher water level in the main wash
and rinses and an extra rinse in the
COTTONS programme
G Switch the washing machine off with
the I-ON/0-OFF button.
The
Water plus
button has now been al
-
located the setting you have chosen.
This setting will remain in memory until
another setting is programmed.
Programmable functions
63
To Next Page
Loading...
