Memory Function
If an additional option(s) is selected
for a programme, and / or the spin
speed is altered, the machine stores
these changes in memory at the start
of a programme.
When that particular programme is cho
-
sen again, the display will show the ad
-
ditional option(s) and / or spin speed
which have been stored for that
programme in the memory.
The washing machine is delivered with
the memory function de-activated.
Follow steps A to G to programme
and store in memory.
The programmable functions are acti-
vated to call up further features not
shown on the control panel by using the
additional option buttons in combina-
tion with the programme selector.
Before you begin, first ensure that:
–
The washing machine is switched off.
–
The drum door is closed.
–
The programme selector is at
Finish
.
A Press the START button and keep it
pressed in whilst carrying out steps
B to C.
B Switch the machine on with the I-ON/
0-OFF button.
C Wait until the START indicator light
comes on . . .
D . . . and then release the START but
-
ton.
E Turn the programme selector to the
COTTONS 30°C position:
If the
Soak/Pre-wash
sequence indica
-
tor light:
does not flash = the Memory
function
is deactivated.
flashes = the Memory function
is activated.
F Press the START button to activate or
deactivate the Memory function op-
tion.
G Switch the washing machine off with
the I-ON/0-OFF button.
The setting you have selected is now
stored in memory and will remain so un
-
til you alter it.
Programmable functions
66
To Next Page
Loading...
