Top-up rinse for COTTONS
When this is activated, additional wa
-
ter flows into the drum at the end of
the main wash to cool the suds down.
Hot suds can damage plastic drain
-
age pipes.
Top-up rinse takes place when temper
-
atures of 95°C and 75°C are selected.
Top-up rinse should be activated:
–
to prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
– where the drainage pipes do not
comply with DIN 1986.
The washing machine is delivered with
the Top-up rinse for COTTONS deacti-
vated.
Follow steps A to G to programme
and store in memory.
The programmable functions are acti-
vated to call up further features not
shown on the control panel by using the
additional option buttons in combina
-
tion with the programme selector.
Before you begin, first ensure that:
–
The washing machine is switched off.
–
The drum door is closed.
–
The programme selector is at
Finish
.
A Press the START button and keep it
pressed in whilst carrying out steps
B to C.
B Switch the machine on with the I-ON/
0-OFF button.
C Wait until the START indicator light
comes on . . .
D . . . and then release the START but
-
ton.
E Turn the programme selector to the
COTTONS 40°C position:
If the
Soak/Pre-wash
sequence indica
-
tor light:
does not flash = the Top-up rinse for
Cottons
has not been
activated.
flashes = the Top-up rinse for
Cottons
has been activated.
F Press the START button to activate or
deactivate the Top-up rinse for COT
-
TONS option.
G Switch the washing machine off with
the I-ON/0-OFF button.
The setting you have selected is now
stored in memory and will remain so un
-
til you alter it.
Programmable functions
65
To Next Page
Loading...
