Before using the machine for the first
time ensure that it is correctly
installed and connected. See the
relevant section under "Installation".
Also check that the fluff filter is
securely tightened. Otherwise there
is a risk of water leakage during use.
For safety reasons spinning is not
possible until the machine has been
prepared for using for the first time. To
activate the spinning function you must
run a wash programme without laundry
and without detergent.
Using detergent could result in an
excessive build-up of foam.
This also activates the ball valve. The
ball valve prevents detergent escaping
from the suds container into the sump
during a wash programme, thus making
maximum use of the detergent.
^ Turn on the stopcock.
^
Press the I-ON/0-OFF button in.
^
Turn the programme selector to
COTTONS 40°C.
^
Press the "Spin" button repeatedly to
select
Without spin
.
^
Press START.
When this programme has finished turn
the programme selector to
Finish
. Your
washing machine is ready for using for
the first time.
Before using for the first time
13
To Next Page
Loading...
Need help?
General
