Soak
A length of time of between 30 minutes
and 2 hours can be programmed in 30
minute increments for the soak
process.
If the soak button is pressed the
selected soak time will be carried out
for the period selected before the wash
programme is run.
The machine is set as standard to a two
hour soak time.
Follow steps A to G to programme
and store in memory.
Before you begin, first ensure that:
– The washing machine is switched off.
– The machine is properly closed.
– The programme selector is at
Finish
.
A Press the START button and keep it
pressed in whilst carrying out steps
B to C.
B Switch the machine on with the
I-ON/0-OFF button.
C Wait until the START indicator light
comes on . . .
D . . . and then release the START
button.
E Turn the programme selector to the
MINIMUM IRON 60°C position:
The
Soak/Pre-wash
sequence
indicator light will briefly flash once
every 2 seconds, to show that a soak
time of 2 hours is stored in memory.
F Each subsequent press on the
START button selects a different
setting.
If the
Soak/Pre-wash
sequence
indicator light:
– flashes x 1 = the soak time is
2 hours
–
flashes x 2 = the soak time is
1 hour 30 minutes
–
flashes x 3 = the soak time is
1 hour
–
flashes x 4 = the soak time is
30 minutes
G Switch the machine off with the
I-ON/0-OFF button.
The
Soak
button has now been
allocated the setting you have chosen.
This setting will remain in memory until
another setting is programmed.
Programmable functions
63
To Next Page
Loading...
Need help?
General
