Memory function
If an additional option(s) is selected
for a programme, and / or the spin
speed is altered, the machine stores
these changes in memory at the start
of a programme.
When that particular programme is
chosen again, the display will show the
additional option(s) and / or spin speed
which have been stored for that
programme in the memory.
Except: Delay start and buzzer; the
buzzer is active in all programmes until
it is switched off.
The washing machine is delivered with
the memory function deactivated.
Follow steps A to G to programme
and store in memory.
The programmable functions are
activated to call up further features not
shown on the control panel by using the
additional option buttons in
combination with the programme
selector.
Before you begin, first ensure that:
–
The washing machine is switched off.
–
The drum door is closed.
–
The programme selector is at
Finish
.
A Press the additional option buttons
Intensive
and Water plus at the same
time, hold pressed in and. . .
B . . . switch the machine on with the
I-ON/0-OFF button.
C Let go of all these buttons. P 0
appears in the display.
D Turn the programme selector to
Separate rinse
:
E The P will now flash in the display
alternating
with the number 11
In addition, one of the following will
appear on the right of the display:
0 = Memory function is deactivated
or
1 = Memory function is activated
F Press the START button to change
from one to the other. The display will
change accordingly from 0 to 1 or
from 1 to 0.
G Switch the washing machine off with
the I-ON/0-OFF button.
The setting you have selected is now
stored in memory and will remain so
until you alter it.
Programmable functions
68
To Next Page
