Miele W 820 - Changing programme sequence

Changing the programme sequence
Selecting a programme
The programme can only be started
when:
The machine is switched on.
The drum door is properly shut.
The programme selector switch is at
the “Finish/Start” position.
Turn the programme selector switch to
the required programme.
To cancel a programme:
Turn the programme selector switch
to the “Finish/Start” position.
To interrupt a programme:
Switch the machine off. To re-start a
programme switch the machine on
again.
To change an incorrectly selected
programme:
Turn the programme selector switch
to “Finish/Start”. When only the “On”
LED is illuminated a new programme
can be selected.
To change a programme where the
child safety option had been set see
page 18.
During a programme it is possible to
omit one or more programme stages
or
repeat one or more programme
stages.
To omit a programme stage:
a programme stage must first be
reached before it can be omitted:
Turn the programme selector to “Fin-
ish/Start”.
As soon as the programme sequence
lamp for the stage at which the pro-
gramme should continue starts flashing:
turn the programme selector switch
to the appropriate programme within
3 seconds.
To repeat a programme stage:
a programme stage must have finished
before it can be repeated:
Turn the programme selector switch
to “Finish/Start”.
When only the “On” LED is illuminated:
a new programme can be selected.
After approx. 5 seconds, turn the pro-
gramme selector switch back to “Fin-
ish/Start”.
Once the indicator light of the pro-
gramme stage to be repeated starts
flashing:
turn the programme selector switch
to the appropriate programme within
a period of 3 seconds.
14