Installation
Levelling the machine
The machine must stand level to en-
sure smooth operation. Check with a
spirit level.
The feet are levelled using the leg level-
lers as follows:
Unscrew foot or feet until the ma-
chine stands level.
Hold the foot tight using a pipe
wrench.
Tighten the counternut using a
screwdriver as indicated.
Building under
It is possible to install this appliance
under a continuous worktop/in a kit-
chen run:
A special building under kit * is re-
quired.
The machine lid must be replaced
by a cover plate.
This must be fitted by a suitably com-
petent person exactly according to
the fitting instructions included with
the kit to ensure electrical safety.
For installation under a work surface
900/910mm from the floor, a spacer
kit * is required.
Connections for electricity, water and
drainage should be installed in such
a way that they remain accessible
when the machine is in place.
Fitting instructions are included with
the kit.
All parts marked * are available from
the Miele Spare Parts or Sales Depart-
ment.
33
To Next Page
Loading...
