Miele W1930 - INSTALLATION INSTRUCTIONS; Washer and Dryer stack; Fitting or changing the decor panel

Washer and Dryer stack
A Miele tumble dryer can be stacked
with the washing machine. A stacking
kit* is necessary and can be pur-
chased from the Miele Spare Parts De-
partment.
All parts marked* are available from the
Miele Spare Parts or Sales Department,
and must be fitted by a suitably compe-
tent person according to the instruc-
tions supplied with the kit.
Fitting or changing the decor
panel
Note: The door should be shut for fit-
ting or changing the decor panel.
Remove the 4 screws from the decor
strip on the door catch side of the
door and remove the decor strip.
Unscrew the remaining 7 screws
from lower and side decor strips until
the decor panel bows slightly and
can then be taken out or put in place.
Re-assemble in the reverse order
and tighten the screws.
Decor panel dimensions
(The figures given in brackets indicate
the tolerance level in mm.)
Panelthickness
1mmto1,5mm
Panelthickness
1,6mmto4mm
width 587 (-1) mm 587 (-1) mm
height 602 (-1,5)mm 596,5 (-1,5) mm
Panels more than 1.5 mm thick require
an "adapter strip for a 4 mm thick
decor panel". This is available from
your Miele Dealer or the Spare Parts
Department (part # 3763550).
INSTALLATION INSTRUCTIONS
42