Spinning
41
Omitting the final spin (Rinse
hold)
Set the spin speed to (Rinse
hold).
The laundry is not spun after the final
rinse and remains in the rinse water.
This helps to prevent creasing if the
laundry is not going to be removed from
the drum immediately after the end of
the programme.
Ending a programme with a spin
cycle
The display showsRinse hold altern-
ately with the ideal spin speed.
Touch the Start/Add laundrysensor
control to start the final spin.
Ending a programme without a spin
cycle
Reduce the spin speed to 0.
Touch the flashingStart/Add laundry
sensor control.
Interim spin
There is a spin cycle after the main
wash and between the rinses. A reduc-
tion in the final spin speed will also re-
duce the interim spin speed as appro-
priate.
Omitting the interim-spin and
the final spin
Before the start of the wash pro-
gramme, reduce the spin speed to 0.
After the last rinse, the water will be
pumped away and the anti-crease
phase will switch on.
In some programmes an additional rinse
is introduced with this setting.
To Next Page
Loading...
Need help?
General