Running your first programme
Your washer-dryer is now ready for the
first programme to be run.
^
Turn the programme selector to
Cottons.
^
Press the Start/Stop button.
^
At the end of the programme switch
the machine off.
After running the first programme, the
load sensor has to be calibrated to
zero (as you would with bathroom
scales).
Calibrating the load size sensor to
zero
^ Switch the machine on.
^ Open the drum door.
^ Turn the programme selector to
Cottons.
^ Press and hold the Load % /
Detergent % button in until the
following message appears in the
display:
Zero setting OK
^
Switch the machine off.
The machine is now ready for use.
Before using for the first time
14
To Next Page
Loading...
