Miele WTR860WPM - The Water Protection System

11975871-00
Installation
*INSTALLATION*
The water protection system
The Miele water protection system
protects all parts of the washer-dryer
from water damage.
The system mainly consists of the
following components:
- the inlet hose
- the electronic unit and drainage and
overflow protection
- the drain hose
Inlet hose
- Protects the safety valve from
bursting
The inlet hose can withstand
pressure greater than 14,000kPa.
- The inlet hose has a protective
sleeve.
The inlet hose has metal braiding as
a “second skin” to protect against
damage.
Electronic unit and casing
- The floor tray
Any leaking water is collected in a
floor tray in the base of the washer-
dryer. A float switches off the water
inlet valves. Further water intake is
blocked. The water inside the suds
container is pumped down.
- Overflow protection
This prevents the washer-dryer from
taking in too much water and
overflowing. If the water level
exceeds a certain level, the drain
pump switches on and pumps the
excess water away.
Drain hose
The drain hose is protected by a
ventilation system which prevents the
washer-dryer from being emptied
completely.