Miele WWD 320 - Programmable Functions Setup; Accessing and Navigating Settings

Programmable functions
71
The programmable functions are used
to alter the machine's electronics to
suit changing requirements.
Programmable functions can be
altered at any time.
Programming is carried out in 8 steps
(, ,  ... ) using sensors.
Accessing the programming level
Before you begin, ensure the following:
– The washing machine is switched on
(the programme selector is pointing
to a wash programme).
– The washing machine door is open.
 Touch the Start/Add laundry sensor
and hold it down during step .
 Close the washing machine door.
Wait until the Start/Add laundrysensor
lights up constantly ...
 ... and then release the Start/Add
laundry sensor.
After approx. four seconds,  will light
up in the time display.
Choosing and selecting
programmable functions
The number of the programmable
function will appear in the display as 
and a number: e.g. .
 Touch the  or  sensor to scroll to
the next or previous programmable
function:
Programmable functions
 Keypad tone
 PIN Code
 Control panel switch-off status
 Memory
 Longer pre-wash Cottons
 Gentle action
 Reduce temperature
 Water plus
 Water plus level
 Maximum rinse level
 Suds cooling
 Anti-crease
 Backlight brightness dimmed
 Confirm the selected programmable
function by touching theStart/Add
laundry sensor.